RING COUNTER

A ring counter is a type of counter composed of a type circular shift register. The output of the last shift register is fed to the input of the first register. The hamming distance of a Johnson counter is 1, the hamming distance of an Overbeck counter is 2.

There are two types of ring counters:

• A straight ring counter or Overbeck counter connects the output of the last shift register to the first shift register input and circulates a single one (or zero) bit around the ring. For example, in a 4-register one-hot counter, with initial register values of 1000, the repeating pattern is: 1000, 0100, 0010, 0001, 1000... . Note that one of the registers must be pre-loaded with a 1 (or 0) in order to operate properly.

• A twisted ring counter, also called Johnson counter or Möbius counter (also Moebius), connects the complement of the output of the last shift register to the input of the first register and circulates a stream of ones followed by zeros around the ring. For example, in a 4-register counter, with initial register values of 0000, the repeating pattern is: 0000, 1000, 1100, 1110, 1111, 0111, 0011, 0001, 0000...

Four-bit ring counter sequences[edit]

Straight ring/Overbeck counter						Twisted ring/Johnson counter
State	Q0	Q1	Q2	Q3		State	Q0	Q1	Q2	Q3
0	1	0	0	0		0	0	0	0	0
1	0	1	0	0		1	1	0	0	0
2	0	0	1	0		2	1	1	0	0
3	0	0	0	1		3	1	1	1	0
0	1	0	0	0		4	1	1	1	1
1	0	1	0	0		5	0	1	1	1
2	0	0	1	0		6	0	0	1	1
3	0	0	0	1		7	0	0	0	1
0	1	0	0	0		0	0	0	0	0

File:German malaysian institute

johnson counter

http://www.doc.ic.ac.uk/~nd/surprise_96/journal/vol4/cwl3/report.johnson.gif==Ring Counter (4-bits)== ^[1]

Applications[edit]

Ring counters are used in hardware logic design(e.g. ASIC & FPGA) to create simple finite state machines. A binary counter will require an adder circuit which is substantially more complex than a ring counter. Additionally, the worst case propagation delay on an adder circuit will be proportional to the number of bits in the code (due to the carry propagation). The propagation delay of a ring counter will be a constant regardless of the number of bits in the code. The complex combinational logic of an adder can create timing errors which may result in erratic hardware performance. Last, ring counters with Hamming distance 2(or more) allow the detection of single bit upsets that can occur in hazardous environments.

The disadvantage of ring counters is that they are lower density codes. A binary counter can represent 2^N states, where N is the number of bits in the code, whereas an Overbeck counter can represent only N states and a Johnson counter can represent only 2N states. This may be an important consideration in hardware implementations where registers are more expensive than combinational logic (e.g. FPGA).